Tractor Maintenance : How to maintain your tractor seasonally

Seasonal tractor maintenance task should be carried out effectively to ensure proper functioning of the machine. It is good to work to a full capacity on the farm than to work halfway with a damaged tractor. This is always time consuming and incurs cost to the farmer. To prevent this you will have to make sure you check every inch of the tractor before work starts. Some steps to guide are listed and described below for every farmer to use and should go contrary to it. Knowing how to maintain your tractor seasonally as a farmer will help make your work on the farm more easier and faster.

Read : Used Farm Equipment … How To Make Money From Them

Steps to follow for a successful tractor maintenance

  1. Change and evaluate tractor oil.

The most important tractor maintenance is to warm up the engine and run hydraulics briefly to encourage drainage. Let the engine cool so oil will be safe to handle. When changing any oil, always change the filter, as well. Place a sufficiently large pan or tub beneath both to catch and hold total engine oil volume.

Take time to evaluate the oil for water or other contaminants, such as diesel fuel. Carefully pour off oil from the collection pan, and look for signs of metal filings that can indicate other problems, such as excessive wear of moving engine parts and potential failure. If the oil or hydraulic filters are in canisters, pull them out and shine a light into the canister to detect metal fragments.

loading…


Consider an oil scan or sample program for periodic review of oil quality and a heads-up on other problems. Your dealer or mechanic can point you to a reliable oil-scan service provider. The scan can determine the type of metal filings in your oil, helping your mechanic identify the filings’ possible origin

  1. Change tractor filters.

If workday servicing hasn’t previously identified the need to change air or fuel filters, then industry tests consistently show a 3½-percent increase in power with proper air and fuel maintenance. When it’s time to replace the outer air filter, replace the inner one at the same time.

Oil-bath air cleaners in older tractors should be serviced once per year. Following your owner’s manual’s instructions, open, empty and clean the oil bowl at the bottom of the filter and refill. Clean and replace any pre-filters at the same time.

When changing the fuel filter, begin by clamping or closing off the fuel line. Be prepared to catch fuel in the line leading to and from the fuel filter, as well as any fuel in the filter. Check your tractor owner’s manual to see if fuel-line replacement is recommended at this time. Replace the filter and reattach fuel lines before reopening the fuel line to the tank.

  1. Check spark plugs.

In older gas-fueled tractors, pull spark plugs to check for signs of improper firing, such as carbon buildup. Follow manual instructions closely to identify proper gap and procedures for rethreading plugs without damaging them.

  1. Check the coolant system

You might not need to flush and recharge your small farm tractor’s radiator with new coolant each year; however, seasonal evaluation of water-based coolants with a hydrometer is highly recommended. Wait until the tractor engine has cooled. Cover the radiator cap with a cloth, turn a half revolution to check for any remaining pressure, and remove.

Check inside the filler neck for debris of any kind, indicating a need to flush the system. If you find none, insert the hydrometer hose into the neck, squeeze the bulb and release to fill the column. The “freeze” scale on one side of the hydrometer indicates the freezing point of the solution. It should register less than negative 34 degrees Fahrenheit. The reverse side displays the boiling point. Fully effective coolant should indicate a boiling point above 265 degrees F. If either freezing- or boiling-point requirements aren’t met, flush and replace the coolant. Also replace thermostats at this time. This tractor maintenance tip is highly important.

  1. Check tractor battery

Small farm tractor-battery maintenance should be carried out at least once or twice per year, even if no problems have been noted. Inspect and clean terminals and measure voltage levels. If fluid levels are low, refill with distilled water and recharge. If the charge level remains low, replace the battery.

 

Comments

comments

loading…


loading…


Leave a Reply

Your email address will not be published. Required fields are marked *

PROVE YOU ARE HUMAN * Time limit is exhausted. Please reload CAPTCHA.